- 1). Place your saddle on your horse's back or a saddle stand. Lift up one side of the saddle skirt to reveal the metal stirrup strap.
- 2). Slip the loop at one end of the Wintec Webber over the stirrup strap.
- 3). Thread the end of the Wintec Webber with the T-shaped metal insert through the hole at the top of your English-style stirrup.
- 4). Twist the little T-shaped metal insert so the end runs perpendicular to the length of the leather.
- 5). Poke the little T-shaped metal insert through one of the holes along the Wintec Webber, depending on the length you want.
- 6). Twist the T-shaped metal insert by 90 degrees so the bar turns to a horizontal position. This locks the stirrup into place.
- 7). Pull the stirrup down so it hangs at the bottom of the Wintec Webber leather.
- 8). Repeat with the other side, adjusting the leather to the same length.
Source...