- 1). Drain the pond fully if you're replacing an existing pump. Place your Titan 2000 at the bottom-center of the pond or waterfall before adding water. This placement maximizes the pump's flow and filtration capabilities.
- 2). Cut the non-threaded end of your pump hosing to a length that will reach out from the centralized pump into another section of the pond.
- 3). Press the threaded end of your outtake hosing onto the pump's hose tail, which accommodates various sizes. Seal the connection by using a screwdriver to attach a hosing clamp.
- 4). Thread the hose tail onto the Titan 2000's water outtake.
- 5). Run the pump's electrical cord, concealed under gravel if you'd like, to the nearest electrical outlet but do not plug it in.
- 6). Fill the pond or waterfall with water. Plug the pump in once it's fully submerged.
Source...