A Homemade Automatic Fish Feeder
- 1). Drill two holes, 0.9-inch diameter, next to each other in the top of a one-quart plastic bottle. Place the first two-inch piece of rigid 0.9-inch diameter pipe into one of the holes.
- 2). Use a pea-sized amount of non-toxic, 100 percent silicone sealer to form a watertight seal around the entry hole. Smooth the silicone out with your finger.
- 3). Place the second two-inch piece of rigid 0.9-inch diameter pipe into the remaining hole. Use another pea-sized amount of non-toxic, 100 percent silicone sealer to form a watertight seal around this entry hole. Smooth the silicone out with your finger. Allow the bottle top and silicone to cure for at least a day.
- 4). Pour a small volume of boiling water into the bowl and place one end of the two-foot piece of air line tubing into the bowl.
- 5). Push this end of the two-foot long piece of air line tubing over the end of one of the two-inch long pieces of rigid 0.9-inch diameter pipe. Place the opposite end of the one-foot long piece of tubing into the aquarium. Place one end of a one-foot piece of air line tubing into the bowl of boiling water.
- 6). Push this end of the one-foot long piece of air line tubing over the end of the second two-inch long piece of rigid 0.9-inch diameter pipe. Attach the opposite end of the one-foot long piece of tubing to the exhaust nozzle of your vibrator air pump.
- 7). Plug the electrical timer into a wall power source, but do not turn it on yet. Plug the vibrator air pump into an electrical timer.
- 8). Pour aquarium water to the halfway mark in the one-quart bottle. Add 200 to 300 living brine shrimp to the bottle. Replace the top on the bottle and ensure that it is fitting tightly.
- 9). Invert the one-quart bottle and position it carefully in the wall mounted bracket, just above the aquarium. Set the electrical timer to run for a maximum of 10 minutes every hour. Set the electrical timer to run only during the time that the aquarium light is on.
- 10
Turn on the wall power supply. Air from the vibrator air pump will slowly fill the bottle and displace water and brine shrimp into the aquarium, throughout the day.
Source...