- 1
hole Position
Cut the 2-by-6 to 12 inches in length. Drill directly in the center of the board and countersink one side, creating a space wide enough and deep enough to accommodate one washer and the head of the bolt, which should be small enough to fit through the spool of line. - 2). Run the bolt through one washer and insert through the countersunk side of the board.
- 3
Hardware Order
Slip another washer over the bolt followed by a nut. Tighten down with a wrench. - 4). Slide the spool over the bolt and screw a second nut onto the bolt to secure the spool, leaving enough room for it to spin freely.
Source...