- 1). Set the material that will receive the brass thread insert onto the worktable.
- 2). Read the insert installation instructions to determine the size of the pilot hole that you need to drill in the base material to accommodate the brass thread insert.
- 3). Select the drill bit from the drill bit set that matches the size of the pilot hole required for the self-tapping brass thread insert and secure in the chuck of the variable speed drill motor.
- 4). Put on your safety glasses to protect your eyes from flying debris.
- 5). Align the tip of the drill bit where you need to drill the hole in the base material, and press the trigger of the drill motor to drill the pilot hole for the brass thread insert.
- 6). Secure the square end of the brass insert installation tool into the tap tee-handle.
- 7). Thread the brass thread insert onto the threaded end of the installation tool.
- 8). Place the end of the brass insert into the pilot hole that you drilled in the base material.
- 9). Turn the tap tee-handle to thread the brass insert into the base material. Stop turning the brass insert when the top of the insert rests slightly below the surface of the base material.
- 10
Reverse the direction of the tap tee-handle to remove the installation tool from the brass thread insert. - 11
Test the installation by threading a bolt into the brass insert. The insert should not move when you turn the bolt into the brass insert.
Source...