- 1). Remove all of the exposed screws on the door panel, around the door handle, and in the armrest using a Phillips head screwdriver.
- 2). Lower the windows down as far as it can go.
- 3). Disconnect the wiring harness from the power window controls and remove the armrest and door handle.
- 4). Remove the speaker from the lower corner of the door and disconnect it from the wiring harness.
- 5). Pry off the door panel using your hands or a flathead screwdriver wrapped in a shop rag. Start at the lower corner and work your way around until the entire panel pops off.
- 6). Loosen the brass mounting bolt on the lower corner of the door.
- 7). Use the hole where the speaker was and move the window until it slides into the power window track.
- 8). Tighten the brass mounting bolt.
- 9). Reattach the door panel to the door by pushing it until all the tabs snap into place.
- 10
Snap the wiring harnesses for the speaker and the power window control back into place. - 11
Screw the armrest, speaker, and door handle into place with the screws your removed earlier and a Phillips head screwdriver.
Source...